When replacing a PCB you will be issued with a universal
replacement. This replacement PCB needs to be programmed with an infra red
controller.
Some systems may only have hard wired controllers installed
and the infra red controller that came with the unit may be missing. Not all
hard wired controllers allow the PCB function to be programmed. It is advised
that engineers keep one of the infra red controllers on their vans at all times
to ensure that this situation is avoided.
Ilustrasi Remot AC Samsung |
Ilustrasi Remot AC Samsung |
- Step One
Enter the option set up mode by removing the batteries from
the controller. Re-insert the batteries
whilst holding down the “UP” and “DOWN” arrows.
The screen display should be as follows. If not, press
“MODE”.
- Step Two
Enter the first half of the option number. In this example
option number 045770- Ic8000 is used. This will not be the option code you
input.
In Table One of the sequence below, The “0” represents the
mode for the first half of the number to be inputted.
Ilustrasi Remot AC Samsung |
- Step Three
Enter the second half of the option number. In this example
option number 045770-Ic8000 is used. This will not be the option code you
input.
In Table Seven of the sequence below, The “1” represents the
mode for the second half of the number to be inputted.
Ilustrasi Remot AC Samsung |
- Step Four
Check your selection. Press the MODE key to select and check
the first part of the sequence beginning with “0”.
Press the On/Off button. The unit will make a sound to
confirm receipt of the instruction.
Remove the batteries from the controller. No need to press
any buttons.
Re-insert the batteries. Point the controller at the unit
and press the On/Off button to initiate TEST RUN.
Jika ada kesulitan dalam melakukan tindakan bisa hubungi kami. Wijaya AC
0 komentar:
Post a Comment